A middle layer edge is stuck or flipped
Quick answerIf every edge on top has yellow on it but the middle layer isn't finished, a middle edge is stuck in the wrong slot or flipped. Turn the cube so the bad slot is front-right, do U R U' R' U' F' U F with any top edge to pop it out to the top, then insert it the normal way.
Loading the 3D cube…
How to spot it
- All 4 top edges have yellow on them.
- A middle edge has the right colours but they’re the wrong way round (flipped).
- A middle edge sits between the wrong two centres.
The fix
- Turn the whole cube so the bad slot is at the front-right.
- Do the right insert: U R U' R' U' F' U F. The stuck edge pops up to the top.
- Now line it up above its centre and insert it right or left as normal.
Full walkthrough: Step 4: Second layer
Questions
Does it matter which top edge I use to pop it out?
No. Any top edge works; it will just go into the slot and push the stuck one out.
Why did it go in flipped?
Usually the edge was lined up with its top colour instead of its front colour. Match the front colour to the centre first.